Newland HR200 User's Guide download pdf (Page 25)

nlscan.com

Page 16

Introduction

There are 3 ways to program (conﬁgure) the Engine, Code Programming, Command Programming, and

QuickSet Programming.

Code Programming

The Engine reads a set of specially encoded barcodes to program features. In the following sections, we will

explain the options and features available and provide the barcodes to program them.

This method of programming the Engine is most straight forward. However, it requires manually readings of

each barcode. As all manual operations, errors are more likely to occur.

Command Programming

The Host can send the Pro CMD strings (see the chapter of Software Interface) to program the Engine. In the

following sections, the Pro CMD strings will be included with the barcodes for Code Programming.

A ﬁxture, such as EVK3000 or other simplier circuit board, could be used to program the Engines before they

are installed into your equipments or systems. Another alternative is to design the conﬁguration capability in

your equipments or systems.

This method of programming the Engine could be automated. A software program can be developed to

download all the conﬁguration data to the Engine.

QuickSet Programming

QuickSet is a Windows based GUI program for Newland Auto-ID bar code readers. It displays decoded

data and captured images. The engine with its circuit board can be easily conﬁgured through the interface of

QuickSet.

This method of programming the Engine is similar as the Command Programming. QuickSet is a software

program developed for Newland Auto-ID products .

Note: The programming results are restored in non-volatile memory. They will not be lost when the Engine is

powered off.

Programming the Engine

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 155 156

No comments

Newland HR200 User's Guide Page 25